Main sectors of use: automobile connectors and electronics domestic appliances tooling

• Main features
• Locking by Hirth gear teeth and indexing by Manifold
• Units with fixed or turning ends with variable drilling ratio
• Differential tapping machine
• 1 counter-spindle mounted on the central slide to support the cutting part (cutting without dog point)
• Fanuc control (Power mate D).
• Cross-drilling facility by stopping the spindle (on request)
• Back-operation facilities in hidden time, such as:
   •   internal rear angle working
   •   counter-drilling
   •   long turning
  
• Opening the clamp by pneumatic control to facilitate new bar feed
• More than 300 units available
• 205° working
• Up to 75 parts per minute
• Facility to work on 2 parts per cycle, up to 120 parts per minute

This lathe benefits from almost 40 years' of experience with multispindles derived from the AS-14 and SAS-16 DC machines. By way of its new design, the SAS-16.6 provides even greater precision with the parts produced.

The Fanuc control makes the lathe even more user-friendly, thereby offering a large range of use.

The slide moving along the central shaft, the cross-slides, independent feeds, counter-spindles - all these strategic units are controlled by a single camshaft located in the upper central section of the machine.

Flat cams for the slides and bell cams for the slide rail, independent feeds, counter-spindles... all these parts are readily accessible.

This lathe was conceived for high production rates.